Nokia Lumia 800 Teardown - Disassemble & Reassemble - Battery & Case Replacement

For spares try http://www.etradesupply.com/nokia/nok... which also gives me credit.
USB Charging Port Replacement needs the use if a 'hot air' soldering iron' a local TV repair shop should have the tools and skills to do this.
Screen Change Only    • Nokia Lumia 800 Screen Repair / Repla...  
Screen Frame Swap    • Nokia Lumia 800 & N9 Screen Frame Cha...  
Fully detailed guide that should come in handy for anyone wishing to change the case, headphone socket, speaker etc.
Skip Intro: 0:27
Remove Battery 3:39 (BV-5JW 1450mAh 3.8v 5.5Wh) Same as N9
Earpiece 4:50
Hot Air Needed 5:40
Headphone Socket 9:09
Reassembly 10:42
Small Magnet 11:29
Front Microphone 13:20
Earpiece Rubber Gasket 13:56
Insert Battery 15:15
Screen on 17:33
If the accelerometer is not working try replacing the proximity sensor.

The USB door is the same as the N9 and does 'pull off' but unless you have a replacement it will be floppy when you put it back on.
If you TURN IT ON before the screen is connected you will need to reset the phone by disconnecting the battery for a few seconds.

I used a fan heater for the hot air to soften the glue.

High Resolution Scan of the mainboard (5000x5000) 7Mb
http://mymail.pwp.blueyonder.co.uk/lu...

Shot with a Panasonic HDC-SD700

Scan of small circuit board http://mymail.pwp.blueyonder.co.uk/am...

**Someone asked if I could make a video on only replacing the digitizer.
The AMOLED display is made of glass and is 0.45mm thick, even with my patience and experience I seriously doubt I could separate it from the digitizer without breaking it.
This shows how hard it can be    • Lumia 800/900/N9 Glass Screen Only