Скачать или смотреть BLINKING LED and PRINTOUT_MESSAGE using L476RG_STM32_BOARD

BUILD PROJECT using L476RG_STM32_BOARD
OPEN-SOURCE PROGRAMS L476RG_STM32_BOARD
BEST and SIMPLEST L476RG_STM32_BOARD PROJECT
-----------------------------------------------------------------------------------------------------------------------------------------------------
**In case you had any question I will be happy to reply, please leave a comment below**

⌚ Timestamps
0:00 Introduction
4:00 Generate code
5:55 Main part of the code
6:19 Set a label for the target PIN on the board
7:47 Define INCLUDE library and VARIABLES
9:53 Find the PINOUT for the L476RG_STM32_BOARD
10:50 Compile, Debug and RUN the program
11:37 Check Terminal tool (Cutecome) the output and printed data

***Important notes--------------------------------------------------------------------------------------------------------------------
The target LED on the board is LED(2). In the os.mbed.com scheme has been written LED(1) they did mistake.
No need to reset the board by pushing button in l476RG , wl55jc as it will restart automatically after uploading (FLASH) the board via cube-IDE.

For the first time you while debugging your code to the board, you may see an update message for "newer firmware version for the ST-LINK" you can do as following steps:
Open in update mode - Don't check change type ..- Upgrade

To see how to download cube-IDE you may see my previous video:
   • BUILD LORAWAN END NODE using WL55JC STM32-...  

👋 Additional resources--------------------------------------------------------------------------------------------------------------
Links for downloading STM-cube-IDE:
https://www.st.com/en/development-too...

L476RG_STM32_BOARD documentation and user manual:
https://www.st.com/resource/en/user_m...

L476RG_STM32_BOARD pins out:
https://os.mbed.com/platforms/ST-Nucl...

🎬 Want to watch again? Navigate back to my YouTube channel quickly
   / @amintayebi  
https://github.com/amin-tayebi