Скачать или смотреть PhytoFind: Set up Data Logging

Before deploying your PhytoFind, you will need to set up continuous data logging. Connect your PhytoFind to the computer and open the PhytoFind software.

First make sure that the PhytoFind current date and time are the same the PC’s current date and time. If not, click set to PC.


Then go to Log Setup. Set the start time and date that you would like your data to be collected and set the sampling interval. On this screen, you can also test the wiper.

Once your settings are correct, click start datalogging and quit. Make sure the program closes before unplugging the PhytoFind.


After a few seconds, the program will close automatically indicating that setup is complete. Continuous datalogging is now enabled. Based on your sampling interval, readings will be taken and stored on the PhytoFind’s datalog memory. You can now take continuous readings while your PhytoFind is deployed.


The software will configure PhytoFind’s datalog parameters and the sensors will flash 3 times. After the program automatically closes, all power and computer connections should be unplugged.


Whenever power is supplied to the PhytoFind while in continuous datalog mode, there will be a 45 second delay before logging begins. You’ll notice the sensor lights flashing just prior to sampling.


All measurements will be stored into PhytoFind’s memory and can be downloaded at a later time using the Data Download tab in the PhytoFind Software.