1600KN force 3200mm long CNC Press Brake With Delem DA-66T CNC system

Adopt overall welding, after the aging treatment, then adopt overall processing methods to ensure the accuracy and reliability of the whole machine;
Closed-loop control model composed of electric-hydraulic servo valve and grating (measure) ruler;
The up chamber internal of oil cylinder equipped with valve, above oil cylinder, install synchronous valve block, grating ruler to detection the balance of Slider up and down and uniformity of pressure,to ensure the synchronization of the slider and bending accuracy;
Back Gauge X, R , Z1, Z2 controlled by Delem DA-66T CNC system;
Worktable equipped with Wila mechanical crowning, it is automatically adjusted by the Delem DA-66T CNC controller with convenient and accurate;
Ensure the highest control precision, bending accuracy and repositioning accuracy are also reach to the highest level.

Type: WF67K-160T/3200;
Nominal Force: 1600KN
Bending length:3200mm
The distance between two side plates:2700mm;
Throat depth :400mm
Slider travel:200m
Max.open height:500mm.

CNC Controller: DELEM DA-66T CNC Controller from Netherlands;
Hydraulic valve: Rexroth brand from Germany;
Main motor: ESTUN brand servo motor;
Oil pump: Sunny brand from USA;
Electrical component: Schneider brand from France;
Servo motor and drive:ESTUN brand servo motor;
Ball Screw,linear guide:HIWIN brand from Taiwan;
Foot switch: Kacon from South Korea,with emergency switch
Tubing connector :EMB brand from Germany
Standard Amada punch 3pcsx800mm+ 1pcx800mm segmented and
2V bottom dies 3pcsx800mm+ 1pcx800mm segmented;
Grating ruler imported : Germany HEIDENHAIN;
Laser safety protection: FIESSLER brand from Germany ;