Скачать или смотреть Replace the Reclamation Filter | HP Jet Fusion 300 and 500 3D Printer | HP

Learn how to replace the reclamation filter on the HP Jet Fusion 300 and 500 3D Printer Series.

Chapters:
00:00 Introduction
00:16 Remove the old filter
00:34 Install the new filter
00:47 Close the agent door and touch Finish to resume printing

More support options for your HP device are available at http://hp.com/support.

Follow these steps to replace the reclamation filter on the HP Jet Fusion 300 and 500 3D Printer Series:
At the prompt, touch Replace.
Open the agent door of the printer.
Check the wayfinding LED to know which filter needs replacing.
Open the filter access door by pushing the top left corner.
Unlock the latch, pull it up, and then pull out the old filter.
Remove the new filter from its package.
Then install it in the slot.
Close the lid, the latch, and then the access door.
Verify the wayfinding LED is off, and then close the agent door.
Touch Finish & Check and then OK on the printer front panel to resume printing.

Continue the Conversation:
http://hp.care/SupportForums
http://hp.care/FacebookSupport
http://hp.care/TwitterSupport

#HP #HPSupport #HPJetFusion

SUBSCRIBE:    / hpsupport  
SHOP NOW: http://store.hp.com/us/en/

About HP:
HP Inc. creates technology that makes life better for everyone everywhere — every person, every organization, and every community around the globe. Through our portfolio of printers, PCs, mobile devices, solutions, and services, we engineer experiences that amaze.

Connect with HP:
Visit HP WEBSITE: http://www.hp.com
Like HP on FACEBOOK:   / hp  
Follow HP on TWITTER:   / hp  
Follow HP on INSTAGRAM:   / hp  
Follow HP on LINKEDIN:   / hp  

This video was produced by HP.

Replace the Reclamation Filter | HP Jet Fusion 300 and 500 3D Printer | HP