Скачать или смотреть  HOW TO INSTALL PRO DISC WHEEL COVER

Pro disc wheel cover :
.
.
.

Installing a Pro disc wheel cover can give your bike the aerodynamic benefits of a disc wheel without the high cost. Here's a step-by-step guide to installing it properly:

Tools & Materials Needed:
Pro disc wheel cover kit
Scissors or utility knife (if trimming is needed)
Zip ties or mounting hardware (included in most kits)
A clean towel or cloth
Installation Steps:
Clean the Wheel
Clean your rear wheel thoroughly to remove any dirt or grease. This helps the cover fit better and prevents damage.
Remove the Rear Wheel
Take the rear wheel off the bike to make installation easier and safer.
Fit the Disc Covers
Your disc cover comes in two halves. Align each half of the cover to each side of the wheel.
Make sure the valve cutout lines up with your valve stem.
Trim if Needed
Some covers require trimming to fit your specific wheel. Use scissors or a utility knife to carefully shape the edge.
Secure the Covers
Most kits come with small holes around the edge and zip ties or screws to secure the covers.
Align the holes from both sides and insert zip ties or screws through them, pulling tight to secure.
Check for Clearance
Make sure the cover isn’t rubbing against the frame, brake calipers, or chain.
Reinstall the Wheel
Carefully reinstall the wheel on your bike.
Spin it to make sure it turns freely without rubbing.
Final Check
Inflate the tire if needed.
Go for a short test ride to ensure everything is secure and there’s no noise or rubbing

#prodiskwheel #wheelcover #bikewheelcover