Manual Brake Install First Gen S10

In this video I am going to show how to install the Motion Raceworks TBM manual brake kit for first gen S10's. I will show you the fittings and parts that you will need to keep you from searching all over town and the internet to get this kit installed. Along with the manual brake kit, I am also going to install the Wilwood proportioning valve. I hope this helps you out, thanks for watching, please leave a comment, and don't forget to SUBSCRIIBE!!

PLEASE READ THE STRANGE INSTRUCTION SHEET INCLUDED WITH THIS MANUAL BRAKE KIT. IT DETAILS WHICH PORT ON THE MASTER CYLINDER SHOULD GO TO THE FRONT BRAKES AND WICH PORT SHOULD GO TO THE REAR BRAKES PER YOUR VEHICLE CONFIGURATION.


I am not a professional. This video is for entertainment purposes only. I am not sponsored by any company mentioned in this video. I did this install these parts based on my own research and used my own money to purchase the products. The manual brake kit was sent to me the subscriber mentioned in this video.

Don't forget your brake fluid and 1 1/2" hole saw to drill the hole in the firewall. You will also need a short piece of 3/16" brake line to make the two short tubes that connect the master cylinder to the proportioning valve.

LINKS TO PARTS USED
Motion Raceworks Manual Brake Kit
https://motionraceworks.com/products/...


Wilwood Brake Proportioning Valves 260-13190 from Summit Racing
https://www.summitracing.com/parts/WI...

3/16" LEED Brakes Inverted Flare Plugs PL3824
https://www.summitracing.com/parts/LE...

Dorman Brake Line Adapters 785-434D
3/16" x 24 male to 7/16 x 24 female for 1/4" brake line
https://www.summitracing.com/parts/rn...

Titan 51515 1/4-Inch Double Flaring Tool
https://www.amazon.com/dp/B084L1RF8D?...