Honda-Powered Ferrari: Hand-Building the 1 of a kind Hood Vent!

If you want to support the StanceWorks channel and builds, here's the link to the patreon!
  / stanceworks  

Be sure to follow StanceWorks on Instagram: @StanceWorks

Follow me personally on Instagram at @mike_stanceworks

Be sure to support our friends at H&R Springs for helping bring this Honda-swapped Ferrari project to life:
www.hrsprings.com

Laser cutting and bending by SendCutSend - For Fast laser cut parts, click here: https://bit.ly/3ucqjsD

Last but not least, check out the rest of the gang that helps to make this project happen:
www.haltech.com
www.rywire.com
www.rsfuture.com
www.csfrace.com
www.garrettmotion.com
www.turbosmart.com
www.vibrantperformance.com


Timecodes:
00:00 - Intro
00:24 - My Biggest Challenge Yet... A Hood Vent
01:18 - Rewind: The Progess Up to Now
04:13 - Welding Preparation
06:50 - This is a DISASTER!
08:15 - Perseverance Pays Off!
09:57 - Finish Work is TOUGH!
10:44 - The Main Arched Panel
12:02 - New Material in Hand... Progress!
13:15 - The Half-Finished Duct Installed!
13:49 - Is it Good Enough? Let's take a close look.
17:06 - Rear Axle Prep: Disassembly
17:53 - Nimmo Machine to the Rescue... As always
19:35 - The Machined Uprights look Great!
20:15 - More Talking...
21:18 - The Test Fit
21:47 - I can't believe it works!
23:25 - Outro