lexar 256GB flash drive repair part 1

for data recovery call: 855.366.4232
or request your service here: http://www.hddrecovery.ca/contact-us/
Data recovery software PC: http://www.r-studio.com/downloads/SES...
Data recovery software Mac: http://www.r-tt.com/?JGKHD000



if you want to ship your failed device to us for data recovery and free evaluation, simply fill out this form: http://www.hddrecovery.ca/contact-us/

and send your drive boxed with bubble wrap to this address:

HDD Recovery Services
391 Bank St, Suite 201
Ottawa, ON
K2P 1Y3
Canada



Updated 2020 my gear for soldering:
I record all my videos using this HDMI Switcher: https://amzn.to/31LCsq6
Green inspection light https://amzn.to/2DFJoYu
Platter extractor: https://bit.ly/2YhQD2y
Momentary foot pedal switch https://amzn.to/2OSqjZF
Vacuum pump https://amzn.to/364XWxa
Cleanroom wipes: https://amzn.to/2ZLj49G
Programmer https://amzn.to/2DRjL7a
Quick pogo pin adapter for eepROM https://amzn.to/33TYVyO
Microscope: https://amzn.to/2rqWcwr
Vacuum chip pickup tool: https://amzn.to/2tNCSxc
Multimeter: http://amzn.to/2EHKAxO
USB volt/amp monitor: https://amzn.to/3CqLRmc
Microscope camera 21mp 60fps 1080P: https://amzn.to/2Rb5cUq
JBC precision soldering iron and tweezers: https://amzn.to/33MACm8
Hot air station: https://amzn.to/2K7Mztk
Infrared preheater: https://amzn.to/2rYCH1c
Fiberglass scratch pen: https://amzn.to/3uHIGUp
Flux dispenser: https://amzn.to/2spLw4D
BEST Flux: http://amzn.to/2mXJd1b
Wick: http://amzn.to/2mNr0Xh
Solder: http://amzn.to/2mtyC0a
Solder paste for BGA reballing: https://amzn.to/2LrKQCi
NAND BGA rebelling stencil https://amzn.to/33Oq9a5
Gloves: http://amzn.to/2mbHWDI
Fume Extractor (mine is no longer available but this is the new version of the same unit) : http://amzn.to/2mNCmL7

Gear for filming:
small camera: http://amzn.to/2mNw51T
big camera: http://amzn.to/2Ficg9o
Lens on big camera:http://amzn.to/2Cx3fGw
Music by Mark Generous - Subway - https://thmatc.co/?l=61EAECBF
this video:    • lexar 256GB flash drive repair part 1  
00:00 Introduction
00:34 Inspection
05:12 Damaged assessment
10:24 Preparation of the circuit board
11:58 Reball process for the NAND
16:07 Linking controller to the board
18:22 Testing the results
19:18 Outro