How to Perform an O-Ring Service on a STDDPCv2 Controller

This how-to video goes through the steps on how to perform an O-Ring service on a Standard Pressure/Volume Controller v2 (STDDPC v2).

If you encounter any issues following these instructions or need repairs beyond basic servicing please contact [email protected] for further advice.

To purchase your replacement O-Rings, contact the sales team: [email protected]

GDS recommends proactively servicing the o-rings in your controllers every 1-2 years depending on use. This helps prevent leaks that could impact in test results or cause damage over time. Check out our new video guide to servicing our standard controllers on our YouTube channel here. If you have any suggestions for future video guides please let us know via [email protected].

Disclaimer: This how-to video has been prepared by GDS Instruments for customers looking to change an O-ring and perform basic maintenance on a Standard Pressure / Volume Controller V2 (STDDPC v2). It is highly recommended that only O-rings provided by GDS Instruments should be used within the controllers. GDS will not accept any responsibility for damage caused to the controller whilst carrying out any actions.