Скачать или смотреть Spray Paint Nozzle FIX! Broken nozzle / tube! L@@K!!

First off...USE SAFETY GLASSES!! Secondly, PLEASE hit the subscribe button!! For this video, I used a red spray straw off a can of carburetor cleaner, WD40, lubricant, etc. I took 2 drill bits, 1.5mm then 2mm to drill out the tube in the can so the red straw would fit tight. Be sure to DRILL BY HAND, do NOT use a drill to drill the can tube out!!! I put the red straw in a drill and locked down the chuck (like you would lock down a small drill bit in your drill...just want you to understand what I meant). Using small pieces of different grit sandpaper, (one grit may be fine but I used 3 starting with courses grit first). spin the red straw with a drill and with your other hand, wrap sandpaper around the end of red straw to sand it down a little....basically making the outside diameter of red straw smaller so it will fit in the tube inside the can (the tube that broke off and can't be pulled out). I cut the straw aprx 3/4", may need to cut it a lil shorter next time and I pushed it down inside the tube of paint can, VERY slowly I pushed it down in it. If you sand off too much which I have not had that happen yet, just use another piece of same straw. Also, u can try without sanding....I had someone say it didn't need sanding but I wasn't gonna push that hard and spray paint on myself. I then put a small amount of super glue on the red straw sticking out of can then pushed the spray nozzle (the one I said I had off a can off empty black spray paint) down on the red straw. I let it dry then tried it out and it worked!!! I hope you liked the video and hit the like button and subscribe as well....I plan on doing a lot more and BETTER videos since I have received sooo many "Thank You comments" Have a good one! the Menace