Скачать или смотреть RIP Version 1 Configuration in Cisco Packet Tracer: Explanation with CLI Commands

Set up Routing Information Protocol (RIP) v1 on Cisco Packet Tracer in this step-by-step tutorial! 🚀 Whether you're learning dynamic routing for the first time or preparing for CCNA, this video has you covered.

Video Highlights:
✔️ Network Design and IP Address Planning
✔️ Router Interface Configuration Commands
✔️ Enabling RIP and Adding Networks
✔️ Testing Connectivity and Troubleshooting

Router RIP Commands:
Here’s a sample configuration for one of the routers in this video:

Router1:
enable
configure terminal
interface fastethernet0/0
ip address 192.168.1.1 255.255.255.0
no shutdown
exit
interface serial0/0/0
ip address 10.1.1.1 255.255.255.0
no shutdown
exit
router rip
version 1
network 192.168.1.0
network 10.1.1.0
exit
IP Address Table:

| Router | Interface | IP Address | Subnet Mask |
| Router1 | Fa 0/0 | 192.168.1.1 | 255.255.255.0|
| Router1 | Se 0/0/0| 10.1.1.1 | 255.255.255.0|
| Router2 | Se 0/0/0| 10.1.1.2 | 255.255.255.0|
| Router2 | Se 0/0/1| 10.2.2.1 | 255.255.255.0|
| Router2 | Fa 0/0 | 192.168.2.1 | 255.255.255.0|
| Router3 | Se 0/0/1| 10.2.2.2 | 255.255.255.0|
| Router3 | Fa 0/0 | 192.168.3.1 | 255.255.255.0|


Test Your Configuration:
Use the ping command to verify connectivity between networks.
Check the routing table with show ip route to ensure RIP routes are propagating.




#NetworkingTutorials
#CiscoPacketTracer
#RIPProtocol
#RIPV2Configuration
#DynamicRouting
#NetworkingBasics
#LearnCCNA
#RoutingProtocols
#CiscoNetworking
#NetworkSimulation
#VLSM
#ITTraining
#TechTutorial
#RoutingAndSwitching
#PacketTracerGuide
#BytePlayground