Prusa MK3/MK4 Enclosure Built with an IKEA LACK Table

This enclosure is meant to be placed on top of an existing table. I built it this way because I feed my printers from spools placed on roller bearings going through rods hanging from the ceiling of my utility room. I do not need to place the spools on top of the enclosure. I can see and service the printers more easily than with the other LACK-derived enclosures.

The table requires plexiglass. It can be purchased, in pre-cut form, at https://www.printedsolid.com/collecti...

The 3D printed parts are published on my page at Printables https://www.printables.com/@PhilippeL...
https://www.printables.com/model/6277...

This video shows my third table being built. The design has gone through several iterations and I think it now works fine. Most kinks have been removed.