How Do I Make Point Control Slots For Peco Points / Turnouts / Switches?

Описание к видео How Do I Make Point Control Slots For Peco Points / Turnouts / Switches?

A short video to show how I make small slots for the point control rod for Peco 00 gauge points / turnouts / switchs, to pop up through. This may be applicable to other scales too.


Steps:
1. Locate point in the correct position.
2. Move point blades to one side position.
3. Drill 1mm hole though the tie rod centre hole into the board.
4. Move point blades to other side position.
5. Drill another 1mm hole through the tie tod centre hole, into the board.
6. Remove point.
7. Open out both holes all the way through the board using 2mm drill.
8. Mill the material between the holes away by "waggling" the 2mm drill towards the other hole.
9. Clean up the slot with a small file.

Комментарии

Информация по комментариям в разработке