Скачать или смотреть Alu honeycomb panel milled and bent by Alu Bender

Tecnology: Muratori Machines Alu Bender

Materiale: Aluminum composite panels with aluminum honeycomb core

Processing: Milling and bending of the alu skin to cover the core

Task requested by the Prospect: Milling the rear skin of the panel and folding the main skin to cover the exposed edge in a single pass.

Sectors: Construction, Architectural facade panels, Cladding

The customer uses a composite panel with aluminum skins and an aluminum honeycomb core. The skins are approximately 0.8 mm thick, and milling must be particularly precise to ensure that the bending score is 0.4 mm. Alu Bender, with its highly precise and secure drive system, allows the panel to be guided under the cutterheads for fast and accurate processing. The bending rollers, with their special adjustment, also allow a bending radius that does not damage the bending line where the paint or the aluminum itself could be damaged.
The feed unit is equipped with automatic speed control that allows the panel to be slowed down when precise milling is required, such as at the corners.

Focus on/Highlights - ENG:
⁃Speed of combined milling and bending operations
⁃Bending process that does not damage the thin skin of the panel
⁃Cleanliness of the machine and panel
⁃Work ergonomics

____________

What is Alu Bender? A milling and bending machine for different kind of panels mostly used in architectural facades industry.

Originally made for ACM (aluminum composite material), Alu Bender can process the edges of Alu honeycomb panels, HPL and fibercement.
In ACM and honeycomb panels the process consists of milling off the undesired material (normally the back face or skin) and then bending the fin remained to cover the edge determining the hemming.
This process allows a higher protection for the edges but also improves the quality overall of the panel.

With a similar process but with different tooling the aluminum honeycomb panels are milled and bend in order to close the edges and protect the 4 sides.

HPL has s slightly different concept. When cut by saw blades the edge is full of chatter marks and also there is a need of bevel both top and bottom of the edge. Alu Bender simply removes few decimals of material flattening the edge and removing the chatter marks. After that process a second unit with two independent HF motors bevels or makes a radius on both top and bottom, IN THE SAME PASS.

Same thing applies to fibercement except for the auto application of Luko liquid for water resisting edges.

Discover more: https://muratorimachines.com/en/machi...