How to Build a Ford 302 Small Block - Part 8: Intake Manifold, Oil Prime, Valve Covers!

Today we continue our Ford Windsor 302/347 stroker build with part 8! This is how to put on your intake manifold, priming your engine for start up, installing thermostat with housing and, putting on your valve covers! We are sponsored by ‪@SummitRacing‬ and they have been the very best sponsor of all time make sure you go show them some love!

We are getting closer and closer to getting our stroker motor here on the dyno and seeing just how much power we can crank out of 347 cubic inches. Thanks so much for watching, if you have any questions leave them below and I will try to get to them.

Intake Manifold Gasket: https://www.summitracing.com/parts/fe...

Intake Manifold: https://www.summitracing.com/parts/su...

Thermostat: https://www.summitracing.com/parts/su...

Thermostat Housing: https://www.summitracing.com/parts/rn...

Oil Primer: https://www.summitracing.com/parts/su...

Zinc Additive: https://www.summitracing.com/parts/lu...

Oil Filter: https://www.summitracing.com/parts/su...

Valve Cover Gasket: https://www.summitracing.com/parts/su...

Valve Covers: https://www.summitracing.com/parts/pr...

RTV: https://www.summitracing.com/parts/pt...

Instagram:   / ryansgarage408  

If you have a car question ask it completely free at https://www.2carpros.com/questions/new



*Disclaimer: Please use all safety precautions