Скачать или смотреть ARES Panel – The single 3D printable face that becomes anything

I’ve been working on these for years and they’re finally available now:
3D-printed ARES Modules, built for real architecture.
They’re my take on a true 3D-printed LEGO brick — one single part with full x, y, and z-axis spring-loaded connections that lets you build anything, no extra fasteners.
My ongoing research is all about one folding ratio: √2 ≈ 1.414. One fold, one crease, one rule. It’s the same geometry I found powering Egyptian pyramids, Greek columns, and the “impossible” Byzantine domes.
I just made it physical. The reason my panels hold real loads and never sway or collapse — even when the whole structure walks or cycles compression and decompression — is because I print actual Byzantine burial vaulting straight into every ARES panel.
They print completely flat. The nozzle follows continuous parabolic vault paths, layer by layer up the Z-axis, exactly how Byzantine masons built domes brick by brick. No supports needed; every vault bridges itself. Hundreds of layers stack into a self-bracing 3D lattice.
When stress hits (wind, quake, walking motion), the vaults push against each other like the pendentives in Hagia Sophia — the harder you load it, the stronger it locks.
How you use them:
Click two panels → rigid wall
Bend a hinge 90° → corner or doorway
Leave it loose → working door or vent
Swap any face → screen, solar, window, brace
Six panels → airtight, load-bearing cube
Print flat → one paper fold → click → it locks forever.
Stack cubes. Nest them. Add legs.
A handful of my panels becomes a walking pyramid right in front of you.
That’s what I’ve been building. Now it’s here.
$20 x 1 Ares Pod 250x250x 60. (min order x20)
$40x1 Ares Pod 400x400x 110. 60. (min order x10)
Contact us x1 Ares Pod 800x800x240.(min order x10)
https://www.stlgalaxy.com/aresorder
Use our Pod Wall Designer.
The file is available if you have your own 3D printer. Reach out.