3D Printed Monitor Speaker

Become a Member of The Daily HiFi Crew
https://bit.ly/dailyhificrew
AFFILIATE LINKS (Use our links if you would like to support our channel)
Crutchfield: https://howl.me/ckjnFE0G7s5
Amazon: https://amzn.to/3rZcX3U
Best Buy: https://howl.me/ckjnJ0R0K4k
Target: https://howl.me/ckjnK7A6ePh

Disclaimer: This may contain Affiliate links which earn a commission if you purchase using those links. This is at no additional cost to you.

DHF Crew Merch: https://shop.dailyhifi.com
Listen to the audio-only version of this podcast: http://anchor.fm/dailyhifi Welcome to the Daily HiFi Podcast where we talk all things A/V!

Erin interviews the designer of these speakers:    • DIY 3-D printed LCM Monitor Speakers....  
BMR drivers at Tectonic Audio Labs: https://www.tectonicaudiolabs.com/aud...

Erin brings us a 3D printed enclosure with a hi frequency BMR driver from Tectonic. What is the largest thing you 3D printed? How many hours did it take? And for those not into 3D printing, but DIY speakers, would you build something similar to this design? With an obvious change to the port design? Or would you try to recreate it out of wood? Let us know about your DIY endeavors, in the comments section! And thanks for watching!

Join our Aftershow!   / dailyhifi  
Listen to the audio-only version of this podcast on any podcast service or go to: http://anchor.fm/dailyhifi

Follow us on Instagram:   / dailyhifi  
Subscribe to Joe N Tell:    / joentell  
Subscribe to Techno Dad:    / technodad  
Subscribe to Youthman:    / youthman  
Subscribe to Erin's Audio Corner:    / erinsaudiocorner  

Disclaimer: This may contain Affiliate links which earn a commission if you purchase using those links. This is at no additional cost to you.