Finishing the Cylinder Square

Finishing the Cylinder Square. In this video I perform the setup and regrind of my Cylinder Square. I didn't film the lathe work but It was completed by chucking, centering, some modifications to my steady rest and then final turning between centers. The initial grind was complicated as the center on the drive end I was using was not substantial enough for the work. Big shout out to RR in the shop (Randy Richard) for several suggestions concerning the center and inspection. The inspection side is rough and as great as I can do until I get to the point of being able to fix my mill to make other new equipment. Thank you very much for watching. Phil