Sighting in My Compound Bow CBE Engage Hybrid Sight - Ep. 2

After episode 1 of sighting in the Custom Bow Equipment Engage Hybrid Sight, I wanted to make sure i did it right. I emailed CBE explaining some of the difficulty with the instructions that came in the box and they promptly emailed me back with some instructions that were slightly different than what comes in the box. In this video, i start over using the email instructions (see the steps i put below, straight from the email) CBE sent to me.
Steps for a 3 pin sight:
1) sight in the individual pins straight out of the box (micro adjusting, not rapid drive adjusting), at 20, 30 and 40 (if this is your plan for your pins)
2) mark on the sight tape where your indicator needle is
3) Go to 60 yds and use your 30 yd pin (the red one) to hit the target at 60. (you'll need to rapid drive adjust down).
4) once hitting bullseye with the 2nd pin (your 30 pin), make the mark where the indicator is now. Now you should have 2 marks on your tape.
5) now roll your sight back up until the needle is back on the first mark (you'll here this called the "home")
6) the pins are now set to the home position
7) use the red sight tape aligned with the marks on the white sight tape (similar to instructions from the box). Install the tape.
8) Unscrew the red needle and move it to where your sight tape 40 yd mark is (your floating pin)
9) You now have a fixed pin 20, 30 and 40 yd sight, with the bottom pin being your floater for longer shots.

Cheers