Скачать или смотреть RC Gaff Pilot Cutter Build Part 7 Finish

Part 7 of this Build Series finishes the Cutter to the point where the model can undergo In Water Balancing.

The video Plans the Deck Layout and finishes Hatches, Skylight and Cockpit. Thru Deck Fittings lead lines from Spars to Sail Servo. Shaft Tubes are Lubricated, the Rig is Collapsed on deck and the cutter is set into the water to Balance the Waterline with Internal Ballast. This finishes the Build Series.

The Gaff Cutter is ready for Sea Trials in the next video.

Don't miss that one!
Subscribe Today!

00:00 - Introduction
00:54 - Step 1: Planning Parts for the Deck Layout
02:44 - Step 2: Building the Cockpit
05:42 - Step 3: More Work on Hatches, Skylight and Cockpit
08:50 - Step 4: Thru Deck Fittings for Sheet Lines to Sail Servo
11:12 - Step 5: Trial Tabletop Run of Gear
12:50 - Step 6: Lubricating Shaft Tubes
14:11 - Step 7: Review of Work Done on Deck
16:55 - Step 8: Collapsing Rig, Carry Sling and Weighing Model
18:42 - Step 9: In Water Test to Balance Hull to Waterline