Upgrade and add new life to your old 3D Printer with the BIGTREETECH SKR 3 EZ and Klipper

Your old Creality, Prussa, or other brand ( in this case a JGMaker Magic ) can gain additional features and abilities. See how an old 3d printer was upgraded in this video with Klipper.

The BIGTREETECH SKR 3 EZ is a high-performance motherboard that uses the new EZ drivers that can be adjusted from 12V, 24V and 48 volts. The BTT SKR3 ez can be used with Klipper, RepRap and Marlin open-source software. It uses a 480Mhz ARM Cortex-M7 32bit STM32H743VI chip.

Klipper requires a host. For this build, a Raspberry PI 4 was used. Klipper, Moonraker, Fluidd or Mainsail are installed and run on the Raspberry PI 4.

Resources used (I receive commissions that directly contribute to content creation on this site):
You can get the BTT SKR 3 EZ here: https://shareasale.com/r.cfm?b=189092...
https://amzn.to/3AAAgSH
The Heat sink kit I used can be purchased here: https://amzn.to/3p45Eqe

STL FIle for mounting brackets: https://www.printables.com/model/3547...

Klipper generic printer.cfg for the BTT SKR 3 ez: https://github.com/Klipper3d/klipper/...
Klipper Configuration Reference: https://www.klipper3d.org/Config_Refe...
Klipper Configuration Checks: https://www.klipper3d.org/Config_chec...
Klipper Screen Configuration: https://github.com/Klipper3d/klipper/...

JGMaker Magic wire details: https://www.thingiverse.com/thing:365...
JGMaker Video with more details:    • Видео  
Github of my printer.cfg file: https://github.com/Kapman1/JGMaker-SK...