Скачать или смотреть Power Analysis Software - Getting Started: Default Site using Ethernet, TCP/IP communications

Learn how to set up PAS for Ethernet TCP/IP communications with SATEC meters.

This step-by-step video shows you how to configure PAS for Modbus TCP, set your computer’s IP address, and test network connectivity to your SATEC EM133-XM meter.

PAS makes it easy to configure TCP/IP communications for fast, reliable commissioning and power quality monitoring.

What You’ll Learn:

1. How to configure the Default Site in PAS for Ethernet communications
2. Setting the IP address, port (502), and Modbus TCP protocol
3. Adjusting retries and communication settings
4. Configuring your computer’s network settings (IPv4, subnet mask)
5. Using Command Prompt to check IP address and ping the meter
6. Verifying communication and monitoring properties online

Chapters:

00:00 – Intro
00:07 – Default Site configuration for Ethernet
00:19 – Setting meter IP address & Modbus TCP port 502
00:30 – Adjusting retries & saving settings
00:46 – Configuring computer IPv4 settings (manual mode)
01:36 – Verifying computer IP configuration with CMD Prompt 'ipconfig'
01:46 – Pinging the meter to confirm network connectivity
02:02 – Selecting meter and going online in PAS
02:12 – Viewing meter configuration properties
02:47 – End of video

#SATEC #PAS #ModbusTCP #Ethernet #EnergyMetering #PowerAnalyser #Commissioning