PhobGCC 2.0 Assembly Video

This is a video build guide for the PhobGCC 2.0 with PhobVision.

(Apologies for the very very poor image quality. I don't know why my phone camera turned potato.)

The PhobGCC is an open-source Gamecube controller motherboard that uses Hall effect sensors instead of potentiometers to read the stick positions.

To get a board, you can buy unassembled boards on Etsy, or follow the ordering instructions here: https://github.com/PhobGCC/PhobGCC-do...

Written build instructions here: https://github.com/PhobGCC/PhobGCC-do...

Discord for tech support:   / discord  

Hardware, software, and documentation:
https://github.com/PhobGCC/PhobGCCv2-HW
https://github.com/PhobGCC/PhobGCC-SW
https://github.com/PhobGCC/PhobGCC-doc

00:17 Donor GCC desoldering
09:10 Magnet mounting on stickbox
15:10 Breaking mousebites on motherboard
15:49 Prepping wires for trigger paddles
20:03 Z button soldering
21:46 Trigger potentiometer soldering
25:50 C-stick cable soldering
31:39 Trigger paddle wire soldering
33:19 Rumble and PhobVision motherboard pre-tinning
34:38 Stickbox mounting
36:39 Rumble bracket and trigger paddle soldering to motherboard
39:09 Trigger preventative maintenance
41:38 PhobVision backshell drilling
42:50 PhobVision jack and JST connector prep
50:07 Rumble motor soldering
50:40 PhobVision soldering to motherboard and mounting on rumble bracket
55:15 PhobVision jack installation in backshell
55:55 GCC cable soldering
59:38 Reinstallation in shell