Скачать или смотреть Overunity test of flyback into caps then pulsing to load with pinkmotorgenerator

Draw is 20ma X 7vdc = .014watts at 700rpm when NOT filling the 4200uf cap bank with the backemf/flyback and pulsing into the 20 ohm load.

Draw to the motor coils goes up to approx 100ma X 7vdc = .7 watts, and this input watts WHILE the cap bank both fills. and is pulsed out to the load of 20 ohms 4 times a revolution, and while the rpms has dropped down to approx 250rpm..

The ammeter from cap bank to load showed approx 1 amp of current from cap bank to load, with 7vdc in the cap while it is pulsing out that 4 times a revolution at approx 250rpm
7vdc X 1A = 7 watts!

Note there was 1.3A showing on meter before I started filming....during filming amps showing were jumping around at about 700ma to 1A.

Most probably the meter is not averaging the amperage correctly, since rotor is rotating slow at 250rpm and only pulses 4 times a revolution,
So lets say it is more like 1/4 the amps than what is shown, if so that is 250ma X 7VDC output vs 100ma X 7vdc input.....its still overunity.
If calculating using ohms law its 7Vdc into a 20 ohm load, that means 350ma of current flowing, so still overunity. looking at it that way too...
I really need to look at it with scope, see the overlap of voltage and amps and calculate on-time of both but dont have scope here in Belarus.
Also analog meter would be nice to have as well, its not going to jump around like the multimeter does.

Please donate:
https://www.PayPal.Me/dougkonzen