How To: Remove and Seal Tail Light from Water

Описание к видео How To: Remove and Seal Tail Light from Water

Instructions down below


This video demonstrates how to remove and seal a tail light from water.


Step 1: Remove tail light from the vehicle.
Step 2: Use a degreaser to clean up the tail light
Step 3: Wipe down the tail light to make sure it is clean
Step 4: Use the glass sealant to cover up the tail light
Step 5: Set the tail light in the vehicle and set the air control to max heat.
Step 6: Place the tail light back into the vehicle


Done


If possible, please leave some effective criticism so that I am able to improve and proceed to be better next time!



Disclaimer:

Due to factors beyond the control of Motor Mech, I cannot guarantee against improper use or unauthorized modifications of this information. Motor Mech assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Motor Mech recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Motor Mech, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Motor Mech. Any product names, logos, brands, or other trademarks or images featured or referred to within the Motor Mech video are the property of their respective trademark holders. These trademarks are not affiliated with Motor Mech. The respective trademark holders do not sponsor or endorse Motor Mech or any of our online products!

Комментарии

Информация по комментариям в разработке