Volvo Control Arm & Ball Joint Replacement - No Press Needed! (S60, S80, V70, XC70, XC90)

►One of the most common failure points on Volvo P2 vehicles are the lower control arms due to faulty or worn-out bushings. It's always recommended to carry out a full front end inspection to make sure your ball joints, inner tie rod ends, outer tie rod ends, struts, strut mounts, spring seats, etc. are in good shape as well but chances are that you're in need of some new bushings. The bushings can be purchased separately, removed from your existing arms, and the new units pressed back in however the front-most bushing can be troublesome to remove and install without Volvo's special tool so my recommendation is to purchase the entire arm with the bushings already installed. Jay VanGorden, our Volvo Product Manager and in-house Volvo Technician is back at it to show you how to replace the control arms and ball joints on your Volvo.

Shop the Products used: https://hubs.ly/H0cPDby0

The essential information from this video can be applied to the following models:
1999-2006 S80
2001-2009 S60
2001-2007 V70
2003-2007 XC70
2003-2014 XC90

SUBSCRIBE: https://hubs.ly/H0cDnfN0

Check out the Blog: https://hubs.ly/H0cPCdR0

Get free parts from FCP Euro:
https://www.fcpeuro.com/page/lifetime...

Follow FCP Euro on:
  / fcpeuro  
  / fcpeuro  
  / fcpeuro  
https://www.fcpeuro.com/