Скачать или смотреть How to Make a Compact Animatronic Eye Mechanism with 3D Printing and Arduino

This project is an upgraded version of my previous design, a highly compact and robust animatronic eye mechanism which uses 3D printed components and an Arduino microcontroller. If you are able to get hold of servo ball-links and pushrods, and are reasonably competent with 3D printing, this is the eye mechanism project I'd recommend most!

Support me on Patreon for access to all my CAD files!   / will_cogley  

My Setup/Recommendations:
🖨️ My Workhorse 3D Printer: https://shareasale.com/r.cfm?b=237790...
🖨️ Fancy Colour-Changing 3D Printer: https://shareasale.com/r.cfm?b=235472...
🔧 Screwdrivers: https://amzn.to/3WFHXDp
🔌 Power Supply: https://amzn.to/3UYY6lP
🔥 Soldering Station: https://amzn.to/3wAYj5u

All Projects: https://willcogley.notion.site/
Patreon:   / will_cogley  
Discord Server:   / discord  
Contact: [email protected]
Also check the instructable for comprehensive detailed text instructions: https://www.instructables.com/id/DIY-...

Screws: https://amzn.to/3Vmtrjg (this kit should cover you)
Around 40* M2 x 6mm screws
6 10mm M2* screws
6* MG90s servo screws (these come with the servos: https://amzn.to/33VfIlF)
Hobby Components
4 M2* Servo Ball-links: https://amzn.to/3TEbz1R
4 M2 x 25mm* Pushrod Connectors: https://amzn.to/3Pl44uc (keep in mind this is just 2mm threaded bar - you could always cut down a 25mm bolt or some plain threaded rod)
Electronics
Arduino Uno: https://amzn.to/3VfGbYR (or anything that can accept three analogue signals, one digital and communicate through SDA/SCL ports)Adafruit PCA9685
16-Channel Servo Driver: https://amzn.to/4cijGsg
5V Power Supply, around 4A is more than enough: https://amzn.to/49Wqni0
A female DC power jack to match your power supply, to be soldered to the servo driver board: https://amzn.to/43j0KFC
2 axis Joystick: https://amzn.to/2NR4JnY
Potentiometer (optional): https://amzn.to/2r0nADS
Push-to-make switch (Some joysticks have this built in, but its easier to control when it’s separate: https://amzn.to/32Wnvyh )
10k Resistor: https://amzn.to/374seRU
Jumper cables: https://amzn.to/2NToCuw
6* MG90s servos: https://amzn.to/4afx4vv

Also, a pin vice hand drill might be useful for adjusting hole sizes: https://amzn.to/4afx7rb

Contact: [email protected]
Discord Server:   / discord