Bullfrog Spas front panel removal

This video will show you how to take off the front panel of an A, R, and X Series a Bullfrog Spa.

Step 1: Remove trim strips from trim channels by pulling
carefully and firmly, working from the bottom of the trim strip to
the top. Place trim strips aside.

Step 2: Remove door - Carefully pull bottom of door out
toward you. Carefully grab the bottom corner of the door and
pull it out enough that you can slip your other hand in behind
the side of the door about 4-5 inches (10-13 cm) up from the
bottom. From there you will pull the door firmly away from the
spa until the snap on the door pulls out of the snap feature in
the rib. Continue to pull the door away until the second snap on
the other side pulls out. The door can then be dropped out of the
groove on top and removed from the spa.

Step 3: Electrical Disconnect – be sure to disconnect any
lighting or any other electrical wiring that is mounted onto the
door before completely removing it.

Step 4: When removed, lean door against spa.
To reinstall spa door, reverse the instructions above