SmythBusters: Top 5 AR Building Myths

In this episode of SmythBusters, we debunk the top five myths and misconceptions about building AR-15 rifles. We've spent a lot of time reading your comments and noticed some common misunderstandings that need to be addressed. Join us as we set the record straight!

Chapters:

0:00 - Introduction
1:30 - Myth 1: You Must Use a Reaction Rod
7:15 - Myth 2: Raw Aluminum After Lapping
8:10 - Myth 3: Gas Block Alignment Requires Precision Spacing
10:00 - Myth 4: You Must Clamp the Barrel for Muzzle Device Installation
11:30 - Myth 5: Using a Torque Wrench to Remove a Barrel Nut is Bad
16:00 - Conclusion and Q&A
Key Points:

-Receiver rods are great but not the only option.
-Grease protects raw aluminum after lapping, preventing corrosion.
-Gas port holes are oversized and allow for proper alignment without precise spacing.
-Clamping the upper receiver is fine for installing muzzle devices.
-Using a torque wrench to remove barrel nuts doesn't ruin the tool.

If you have any questions or comments, let us know below. Don't forget to like, subscribe, and hit the notification bell for more content.


#tools #howto #tutorial #myths