DIY Router table part 2 - the fence

In this second part of my three part series on building a router table attached to a cabinet saw, I will take you through how I built the fence and with a touch of inception, I use the fence to build the fence! :D

Parts used in this series:
Router - https://amzn.to/39B8vj2
Router plate - https://amzn.to/3MnSgqv
Levelers - https://amzn.to/3MnlYMl
Dust port - https://amzn.to/3nUKI4B
t-track (KM tools) - https://kmtools.com/collections/stop-...
t-track (Amazon) - https://amzn.to/41dsZ6i
Stop block - https://kmtools.com/products/the-katz...

Some of my tools:
Router - https://amzn.to/39B8vj2
Trim router - https://amzn.to/3xdowUH
Pocket hole jig - https://amzn.to/3DxARVG
Woodpeckers stainless steel squares - https://www.woodpeck.com/woodpeckers-...
Cabinet Saw (Similar to mine) - https://amzn.to/43rz0P0
Jig Saw - https://amzn.to/3j0Eom8
Circular Saw - https://amzn.to/3v9Nrab
Brad point bits - https://amzn.to/3K6rnmK and https://amzn.to/3x7uAie
Right angle clamps - https://amzn.to/3uP9zX8
Router Template guide bushing: https://amzn.to/3DcHCOE
Round nose router bit: https://amzn.to/3AWTsty
Countersink drill bit - https://amzn.to/3UmxOs8
Flush trim bit (KM tools) - https://kmtools.com/collections/km-to...