✅Tank Take 2 - Vinyl Wrap in Real-Time

Check us out on Bikeskinz.com and Facebook.com/Bikeskinz. (read more below)

Purpose of this video:
This is a new tank wrap installation video that supersedes the old tank installation videos. Shot in almost real-time, this video shows how to quickly and easily install the wrap for the tank without removing the tank and also trimming to the edge (using 3M Primer 94) in order to save time. Also in this video, you'll learn how to use "Knifeless Finishing Tape", a new product that allows you to create precise cuts for trimming and setting up seams without the risk of cutting into the paint or plastic of your bike's bodywork.

Other Notes:
Some people are worried about open flames around a gas tank. That's fine, feel free to buy and use a heat gun. By the way, DOT-approved gas tanks don't have leaking gas or fumes emanating out.

Some people are worried about cutting with an EXacto knife against paint at the edge and behind trim panels. That's fine too, feel free to use Knifeless Finishing Tape there if you desire.

Some people notice there are no distinct side graphics, so the tank could have possibly been done in one piece. Good point, we often do that especially if there are no distinct graphics and there's a front tank trim piece, it's easy to do a front and back, versus two sides and a top.

Our Company
https://bikeskinz.com
-------------------------------------------------------------------------------
Products used in the video:

Primer 94 Adhesive Promoter:
https://www.fellers.com/fellers-shopp...

Knifeless Line Tape:
https://www.fellers.com/fellers-shopp...