How to program & troubleshoot HomeLink programming Garage Door Opener Buttons - Chrysler Pacifica

A few HomeLink parts on Amazon → http://amzn.to/2h3tR9x
1. To clear the codes: Press and hold the two outer HomeLink buttons, and release only when the EVIC display shows "Channels Cleared". Do not hold the buttons for longer than 30 seconds and do not repeat step one to program a second and/or third hand-held transmitter to the remaining two HomeLink buttons.

2. Programming a button: Position your hand-held transmitter 1-3 inches away from the HomeLink buttons. Simultaneously press and hold both the HomeLink button that you want to train and the hand-held transmitter buttons. Do not release the buttons until step 4 has been completed.
The EVIC display will show "Channel X Training" (where X is Channel 1, 2, or 3). Release both buttons after the EVIC display shows "Channel X Trained". NOTE: If the EVIC display shows "Did Not Train" repeat steps 2--4.

3. Checking to see if it worked: Press and hold the just trained HomeLink button and observe the EVIC display. If the EVIC display shows "Channel X Transmit" (where X is Channel 1, 2, or 3), programming is complete and your device should activate when the HomeLink button is pressed and released. NOTE: To program the remaining two HomeLink buttons, begin with "Programming" step two. Do not repeat step one.
NOTE: If your hand-held transmitter appears to program the universal transceiver, but your garage door does not operate using the transmitter and your garage door opener was manufactured after 1995, your garage door opener may have a multiple security code system (rolling code system). Please proceed to steps 6--8 to complete the programming of a rolling code equipped device (most common garage door openers require this step.
At the garage door opener receiver (motor-head unit) in the garage, locate the "learn" or "smart" button. This can usually be found where the hanging antenna wire is attached to the motor-head unit.

Firmly press and release the "learn" or "smart" button. (The name and color of the button may vary by manufacturer.) NOTE: There are 30 seconds in which to initiate step eight.
Return to the vehicle and firmly press, hold for two seconds and release the programmed HomeLink button. Repeat the "press/hold/release" sequence a second time, and, depending on the brand of the garage door opener (or other rolling code equipped device), repeat this sequence a third time to complete the programming.
HomeLink should now activate your rolling code equipped device.

To program the remaining two HomeLink buttons, begin with "Programming" step two. Do not repeat step one.