How to set up and mix a floor monitor on the Behringer X32

One of the most common questions I receive with the Behringer X32 is how to set up a floor monitor or a floor wedge. In this video I walk you through from the beginning of how to:
- Setup your Behringer X32 for routing for monitors
- How to use sends on fader to mix monitors
- How to put reverb into the monitor

There seems to be a bit of confusion about when I am setting the post-fader tap point later in the video, this is post-fader so that you have volume control of the floor monitor with the mixbus master fader. Setting this tap-point does not make your mixbus a post-fader setup, this was set when we set up our mixbusses earlier in the video. So don't skip over the part where I talk about the setup for the Mixbusses around the 01:40 mark.


Learn more about the X32 Fundamentals Course at https://course.drewbrashler.com.


Link to the blog post: https://drewbrashler.com/2022/intro-t...

Products shown in this video:
Behringer X32 Full Size - https://amzn.to/3KQIrgC

Chapters:
00:00 Intro
00:52 X32 Setup for the Floor Monitor
01:40 Quick Setup of Mixbusses for Monitors
03:40 Assign Mixbus 1 to a Floor Monitor
04:47 Routing Monitor 1 to XLR Outputs
05:22 Routing Monitor 1 to Aux Outputs
06:14 Sends on Fader - Mixing to the Floor Monitor
07:24 Mixing Monitors Using Sends section of X32
09:09 TIP! Use Solo along with Sends on Fader
09:50 How to add reverb to the monitor
12:12 Conclusion