2015 - 2020 Ford F150 Dashcam Hardwire Installation STEP-BY-STEP

This video describes how to hardwire a dash cam in a 2015 - later model F150 pickup truck.

In this installation, I use an Aucee dashcam wiring kit that I have modified by soldering a 30mm twist-lock glass fuse holder with a 2 amp glass fuse, and a 1/4" female terminal connector. I'm also using a Mini/Micro2 fuse tap on the existing 15 amp fuse in the passenger footwell fuse panel.

Maybe the links below can help!

Rexing V1P Dashcam: https://amzn.to/2ymWPxf
If you prefer only a front-facing dashcam: https://amzn.to/2VkMknf

Kingston Canvas Go! 64GB MicroSD card (recommended by Rexing) : https://amzn.to/34NbRbL

Aucee hardwire kit: https://amzn.to/2VFEQKp

Ferrites: https://amzn.to/34Q78G5

Safe auto trim removal tools: https://amzn.to/2VENPvr

Circuit tester: https://amzn.to/3anvVTf

Makita drill and driver set: https://amzn.to/3alhcrR

If you're a Milwaukee fan instead: https://amzn.to/3by0RkU
Or Dewalt: https://amzn.to/34S7Wuq

*I am an Amazon Affiliate member, so a small percentage of purchases you make from those links above go to fund this and other videos.

Inline 30mm glass fuse holder and 1/4" female terminal connector: (any auto parts store will have them)

Micro2 fuse tap: https://ebay.us/bnP5ly (also check at parts stores, like NAPA: https://www.napaonline.com/en/p/NW_72...)

Make sure to consult your owner's manual for less important fuse circuits in your fuse panel (do not tap into anything used for airbags, restraints, or important lights).