Turnigy 9x - 3 Position Switch Flaps Setup

Turnigy 9x (Mode 2) (v2 Firmware) from Hobby King set-up with the flaps operating on the 3 position switch.

Hi guys, when I was putting together my Durafly F4U Corsair, I had a very hard time setting up the flaps on the 3 pos switch. So, now that I did finally figure it out, I thought that there might be a few other guys out there that could benefit from what I found out.

There are other videos on you tube that have different methods of setting up the 3 pos, but I think this is the most straight forward method.

My gear -
Turnigy 9x (Mode 2) (v2 Firmware) Transmitter
Turnigy 8ch Receiver
Durafly F4U Corsair (but works on any plane really)

Note: I have my flap servos set-up at one end of the travel when the flaps are in the neutral position. So, make sure to set-up the control rods and clevis at the right length.