How To End Drill Round Stock (Long Rods Without a Lathe!)

In this video I show you how to drill the end of a round bar / rods / round stock without a lathe. This method works well for long pieces of round stock that will not work with other methods I've seen here on Youtube. You will need a drill press to achieve this center drilled hole.

Check out some of the suggested materials below. As an Amazon Associate I may earn a small commission (at no extra cost to you)
Spare Drill Chuck: https://amzn.to/4eprSqY
Plumb Bob: https://amzn.to/4d6oAHX
Magnetic Protractor: https://amzn.to/3Tx9x3c
Bubble Level: https://amzn.to/3TzdCUC
Center Punch: https://amzn.to/3XLTSzr
Center Drill: https://amzn.to/3XL3KJY
C Channel
Nuts and Bolts
Nozzle or something similar

Please comment below with suggestions to improve this design. This is not intended to replace a lathe...

****************************************************************

If you enjoy and have benefited from my content and are feeling generous I would love your support! You can "buy me a coffee" here:

► https://www.paypal.com/donate/?hosted... ☕

By supporting my channel you are encouraging me to continue with this time consuming endeavor. A lot of time goes into design work, building my projects, filming the videos, editing the videos, etc. Plus it all costs money! Your generosity goes a long way in helping me bring you better content as often as I can!

Follow me on Instagram!

►   / embraceracing   📷

If you liked this video, perhaps you will also enjoy some channels that I personally find inspiring and interesting...

DIY and MAKER:

► The Hacksmith
   / @hacksmith  

► Adam Savage Tested
   / @tested  

► Thomas Sanladerer
   / thomassanladerer  

Car Content:

► Mighty Car Mods
   / @mightycarmods  

► Drivetribe
   / @drivetribe  

#fabrication #tools