Hexacopter Drone Build Project – Part 13 Electronics Installation into Frame

Welcome to the next installment of my Hexacopter Drone Build Project! In this video, I'll be installing the Tattu 12s Smart Battery, mounting the Kore Carrier Board and Cube Orange Plus, installing the HereLink Air Unit and antennas, attaching the HobbyWing XRotor X6 motors, performing all wiring, and setting up the CAN Bus connections for components like the Here 4 GPS, Cube ID Remote ID Module, and HereFlow optical flow sensor. I'll also be attaching the OLED display and mounting a TFMini-S LiDAR.
Follow along as I integrate these essential components into the frame, ensuring a seamless setup for optimal drone performance. I’ll try to detail each step as much as possible to provide clear guidance on the electronics installation process.
For detailed documentation and materials list, visit my GitHub repository: https://github.com/timarcher/Drone

Timestamps
0:00 Intro
2:53 Label the Motor Numbers
5:47 Mount Battery to Tray
10:31 Battery Tray Install
14:49 Battery Cable Sleeving
21:02 Battery Cable CAN Cable Sleeving
25:41 Mount Battery Cable to Frame
37:33 Motor Mounting Prep
42:27 Attach Motor to Tube
53:19 Attach Motor and Tube to Frame
1:02:17 Showing All Motors Attached
1:03:43 Kore Carrier Board Mounting
1:11:12 Motor and Battery Cable Runs
1:13:31 Motor and Power Wires Run, Initial Fit Together
1:14:14 Motor CAN Cables Connected
1:15:35 Mounting the Here 4 GPS Stand and GPS Receiver
1:19:00 CAN Wiring, CubeID Remote ID, and Additional Power Connectors
1:22:56 BEC and Holybro CAN Hubs Mounting
1:24:42 HereFlow and TFMini-S LiDAR Mounting
1:26:08 Compute Board with Raspberry Pi, SwitchBlox and HereLink Air Unit
1:34:10 Antenna L Bracket Mount 3d Print
1:36:13 Antenna L Bracket Mount Assembly
1:41:06 OLED Display Mount
1:42:06 Final View of Assembled Drone