ARGB Device Cable Kits: Tutorial - Connect Bora Digital, ST120 and StrimerPlus to UNI HUB in O11D XL

The ARGB Device Cable Kit lets you take control of more LIAN LI ARGB products either via the Uni Hub or via synchronization with the motherboard.

Supports: Strimer/ Strimer Plus/ Galahad AIO/ ST120/ Bora Digital/ LANCOOL II Side Diffused LED Strip/ O11D XL light bar/ DK-04F&05F light bar

---------------------------------------------------------------------
This tutorial is a handy clip that you can learn how to control the fan speed and light mode of Bora Digital / ST120 / STRIMER PLUS / O11D XL on L-Connect

Kits:
→ 1 × Fan LED Extension Cable (4P)
→ 2 × Y-type 3P Signal Cable
→ Uni Hub

0:00 Kits
0:15 Connect ST120 and Bora Digital on UNI HUB
0:36 Connect STRIMER PLUS on UNI HUB
0:48 Connect O11D XL light bar on O11D XL
0:58 Build

Steps:
Step 1. Group the Uni Fans and connect them to Uni Hub
Step 2. Connect the 4 ARGB cables of ST120 and Bora Digital to Uni Hub with Fan LED Extension Cable (4P)
Step 3. Connect the 3 PWM cable of ST120 to Uni Hub through the fan hub.
Step 4. Connect the PWM cable of Bora Digital to another PWM header on the UNI HUB.
Step 5. Connect Strimer Plus 24 PIN and 8 PIN to their controller and connect the SATA cable.
Press M1 button for 3 seconds to pass ARGB control to L-Connect.
Step 6. Connect the Strimer Plus controller to Uni Hub with Y-type 3P Signal Cable.
Step 7. Connect the O11D XL light bar to UNI HUB with another Y-type 3P Signal Cable.
Press M button 7 times to pass ARGB control to L-Connect.

Note:
Each group of UNI HUB ARGB output supports a maximum of 100 pcs LED.
Each group of UNI HUB PWM output supports a maximum of 3 fans in a row.
Please do not plug any other device at the other header of Y-type 3P Signal Cable while STRIMER Plus controller is connected to avoid insufficient power.

Shop Now ▶
https://www.newegg.com/p/1W7-00BS-00009