Building a Plate Carrier Antenna.

Antenna positioning is probably the most important factor for better range. This system gives you a full length half-wave dipole you can mount on the back of your plate carrier and allows to swap different handheld antennas for best results or different bands. It uses plumbing copper tubing, an SMA chassis connector, BNC-to-SMA connector for the radio and an RG-316 BNC cable. By the way I suggest not using too much radiated power close to your head, especially on higher frequencies, as radio waves can cause heating of some nearby tissues. Consult FCC guidelines on this issue.
Multimeter: https://www.amazon.co.uk/dp/B09GF2FZVY
Buy me a coffee at https://ko-fi.com/gilgsn
Shirts and mugs: https://teespring.com/stores/radio-pr...
Help this channel:   / radioprepper  
Send Bitcoins to: bc1qc5jq4dxt7359sh80lkv9v8rlsgnh322hmn6xyc
Facebook:   / radiopreppers  
Radio Preppers Forum: http://radiopreppers.com
Subscribe on my alternate platform:
https://odysee.com/@RadioPrepper:d

DISCLAIMER: The Radio Prepper logo (depicting a microphone) is indeed inspired from a famous flag created in 1775. It is NOTHING BUT a symbol of freedom and independence. It does NOT imply support to any political group. It does NOT imply, represent nor support any ideology with an intent on harming anyone. Freedom means freedom from persecution based on any human trait or belief such as, non exhaustively, race, gender, religion, sexual orientation or nationality. The Radio Prepper channel is a technology and science channel with a focus on preparedness and use of radio technology for disaster relief and small group communications in times of need. It is apolitical and open to anyone sharing the same interests. Send Ethereum : 0xe7cC2e415E0D2d1De91604B2b693f124dfBCf9B8
Send Litecoin : LYwDy55mZSeb1Czx6JUiTS5YkqjfmWKK5H