Section 1.8 ESteps and Flow Rate

In this video I go over Section 1.8 of Luke's Guide, Esteps and Flow Rate. I have updated the Math in the examples below. Luke now uses a .8 wall on the test cube as it's more accurate.

🛑Subscribe for more: https://www.YouTube.com/theedgeoftech...

🐱‍🏍Share this video with a friend:
   • Section 1.8 ESteps and Flow Rate  

💾 Share this channel with a friend:
   / @theedgeoftech  

EStep Calculation:
100 (commanded Steps) divided by 98 (actual steps taken) = 1.02
1.02 x 93 (Current ESteps) = 94.86
95. is your new ESteps if you round up

Flow Rate Calculation:
Value of all 8 measurements divided by 8 = Average Measurement.
.80 divided by average measurement multiplied by 100 = New Flow Rate.

Example:
.78+.80+.76+.79.+.80+.81+.75+.78 - 6.27 Equals Total Walls Measured

6.27/8=.783 - Total Walls Measured divided by 8 (8=total measurements taken, 2 on each side of the cube)

.8/.783 = 1.02 - Wall thickness (.8) divided by Average of Total Walls Measured (.783)

1.02x100=102. = 102 is the new flow rate.

Luke's Short throw Calibration Test Cube: https://www.thingiverse.com/thing:322...

Luke's Help Guide
https://support.th3dstudio.com/hc/en-...

Disclaimer: Some of these links go to one of my websites and some are affiliate links where I'll earn a small commission if you make a purchase at no additional cost to you. As an Amazon Associate I earn from qualifying purchases.
Ender 3 V2 Amazon: https://amzn.to/2OA9bug
Code: 07ZGQI2J to save some money!

Ender 3 V2 Amazon:https://amzn.to/3qRzLwb
Code: 07GZXYYD to save some money!

Decent Caliper for 3D Printing: https://amzn.to/3elcw8N

Ender 3 Pro on Amazon: https://amzn.to/3ak9BtS

Ender 3 direct from Creality:
Ender 3: https://www.creality3dofficial.com/co...

Ender 3 Pro: https://www.creality3dofficial.com/co...

The Edge of Tech Amazon Affiliate Store Front: https://www.amazon.com/shop/theedgeof...

Support the channel through these links!
PayPal
https://paypal.me/theedgeoftech
Patreon
  / theedgeoftech  

Watch next – Luke Hatfields Help Guide Playlist -    • Luke Hatfield's Help Guide for Creali...  

Recommended Playlist – Community Showcase -    • Community Showcase  

Let’s connect:
Instagram:   / theedgeoftech  
Twitter:   / theedgeofteck  
Facebook: www.facebook.com/TheEdgeofTechOfficial
----------------------------------------Credits-----------------------------------------------------------

Music by Wicked Realm
Album - No More Fairy Tales
Song - Feed
   / @wickedrealm5507