How to Replace Engine Knock Sensor 2006-2013 Chevrolet Impala

Buy Now!
New Engine Knock Sensor from 1AAuto.com https://trq.video/id-1AEKS00048

This video shows you how to install an engine knock sensor on your 2006-2013 Chevrolet Impala. A knock sensor monitors your vehicle’s engine for unusual pulsations caused by things such as engine knock. If a sensor is damaged or malfunctioning, the engine may run poorly, inefficiently, or only in a low speed safe mode, and may also trigger diagnostic codes.

This repair was done on a 2009 Chevrolet Impala LT 3.5L Sedan 4-Door FWD Automatic and the process should be similar on the following vehicles:
2006 Chevrolet Impala
2007 Chevrolet Impala
2008 Chevrolet Impala
2009 Chevrolet Impala
2010 Chevrolet Impala
2011 Chevrolet Impala
2012 Chevrolet Impala
2013 Chevrolet Impala

Tools you will need:
• 10mm Socket https://trq.video/o2E-1AXAA00017
• 13mm Socket https://trq.video/oaaQ-1AXAA00015
• 7mm Socket https://trq.video/o2E-1AXAA00017
• Trim Tool Set https://trq.video/oxM-1AXXX00006
• Push Pin Pliers
• Socket Extensions https://trq.video/oaaQ-1AXAA00015
• Swivel
• Torque Wrench https://trq.video/oLq-1AXAA00044
• Pick https://trq.video/opJ-1AXAA00037

Subscribe:    / @trq  

Check out our playlist:
Chevrolet Impala 2006-2013 9th Generation:    • Chevrolet Impala 2006-2013 9th Genera...  

⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.