Evinrude-Johnson BRP Ignition Switch Wiring and Replacement

Capt. Chris of Buzzards Bay takes a look at a common Evinrude/Johnson ignition switch with integrated clip-on safety lanyard (BRP part No. 5005801). You'll see how the switch is wired from the factory, the basic functions of the six bullet connections, and the operation of the emergency stop feature. You'll also see how to remove your old ignition switch and swap the connections over quickly and painlessly. As a bonus, you'll get Capt. Chris' wiring diagram, suitable for framing :-/ and a short but controversial take on the use of non-conductive greases on marine electrical connections.

ENJOY!

CHAPTERS
00:00 Introduction
00:46 Why replace the ignition switch?
01:50 How the safety lanyard works
02:40 How the switch is wired
07:31 Safety kill-switch mechanism and wiring explained
09:24 The wiring diagram up close
09:39 Removing the binnacle cover and exposing the old switch
12:16 Disconnecting the old switch
13:00 Transferring wiring to new switch
19:10 Protecting wiring connections in a marine environment
22:40 Wrap up and review of wiring diagram