Customize your Proffieboard In LESS THAN 15 MINUTES

If you need a straight-to-the-point guide that walks you through how to add soundfonts AND blade styles to your proffieboard without taking more than 1 hour, then this video's for you.

00:00 Things that you would need
00:36 Installation of ProffieOS and Arduino
01:09 Getting your free Soundfont
01:52 Plugging the SD Card into your computer
03:37 Setting up Arduino
04:30 Setting up your config file
06:20 Placing the blade style code into your config
10:32 Plugging the Proffieboard into your computer
11:22 Uploading the new config file into the Proffieboard
12:52 Checking the new SoundFont and Blade style
13:02 Config file troubleshooting
14:02 Proffieboard detection troubleshooting

Once you've got everything set up and got the hang of it, the whole process of adding new soundfonts and blade styles would actually take less than 5-minutes.

For free and premium soundfonts check out Cosmic Ape at:
https://payhip.com/CAfonts

You can also get more free soundfonts at GreyScale fonts:
https://www.greyscalefonts.com/

And premium and amazing soundfonts at Jaydalorian:
https://jaydalorian.com/

-------------------------------------------------------------------
If your computer still cannot detect the Proffieboard you must:

1. Select STM32 BOOTLOADER on your Arduino by going to tools, programmer, then "STM32 BOOTLOADER"

2. On your Proffieboard (while plugged in), press the BOOT + RESET buttons above the battery slot manually at the same time while plugged-in (please be careful and do not move your board too much)

3. In the Arduino software, type "RebootDFU" command in the serial monitor (Ctrl+Shift+M) then press upload