E7: Tamiya Hornet Custom 20mm Offset Front Suspension

Thank you for watching my video! All products shown can be found here:

Shapeways: https://www.shapeways.com/shops/ampro

Hardware List:
1. 4x 30mm Screw Pins
2. 2x 4.8mm Ball Studs, 6mm stud
3. 2x 4.8mm Ball Studs, 8-10mm stud
4. 6x M3 washers, no more than 0.5mm thick
5. 2x M3 Nut (not nylon locking nut)
6. 4x 4.8mm Ball Cups
7. M3 threaded rod for upper link (length needed is less 50mm, two 20 mm screws can be cut down for this too. Actual length is not known. Dependent on ball cups length)
8. 2x M3x18mm screws
9. 2x M3 nuts
10. 4x 4mm x 6mm brass tubes
11. 2x 3mm x 12mm screws
12. 2x M3 self tapping screws, 8mm long

Other Componets
1. 60mm eye to eye shock, standard bore

Special Tools Needed:
1. 3mm-3.1mm drill bit. Do not use a 1/8" bit

Note: In some cases, original Hornet tie rods are slightly too short and need either updated turn buckles installed. This is not an issue with Re-release hornets as those tie rods are much longer.

Please, visit my sites:
Facebook:   / amproengineering  
Instagram:   / amproengineering  

Many of my designs and threads can be located at
http://www.tamiyaclub.com/forum/index...

If you enjoy the music featured on my videos, please visit Blue Pinto’s official site here:
  / bluepinto  
https://www.reverbnation.com/bluepinto

I always enjoy constructive criticism and would love to know what you think about my designs.

Please subscribe as I have hundreds of other upgrades for many, many other cars, rc cars, toys, and anything else that I think needs upgrading!

**I have no tolerance for disrespectful posts, foul language, cyber-bullying, sexism, homophobia, racism and anything else that has no place in society. This is a family friendly channel so I have soap next to me for every time I say a bad word. Any foul or abusive post will be removed and you will be reported to YouTube.**