Honing the top of my Table saw AGAIN!!

Honing the top of my Table saw AGAIN!! This wasn't by choice. After cleaning a silicone glue mat off ready for more gluing. I though it was dry but just wanting to take no chances I put a towel down on my table saw and finished gluing up my cutting boards. Before we left to spend the day with our grandkid's I went in the shop and removed the clamps from the cutting boards. To my frantic surprise when I removed the towel from the table saw a HUGE brown spot was sitting there. I with no hesitation cleared off the table top shot WD-40 on and with my 400 grit sanded the rust off, wiped it down with mineral sprits and reshot some WD-40 let it set till I returned. In this video I go through the process as if it were my yearly maintenance of the saw and hone once again the top with an added step. This time I do 10 minutes with 1000 grit paper and take the smoothness to another level.

I will never again wax my table again. I've found a futuristic product that is slicker than any wax and better protection. Meet Carbon Method Nano technology. click here for more info.
https://carbonmethod.com/

Harvey Woodworking website:
https://www.harveywoodworking.com/

If you would like to contact them via email here is their address:
[email protected]

You can call them during business hours at 1-(888)-211-0397

Check out my amazon store and help support this channel. Click on the link below:
https://www.amazon.com/shop/theshack

Thank You for viewing, Subscribe, Like and ring the Bell

Follow me on twitter: @backintheshack

Follow me on Instagram:   / back_in_the_shack  

Check out My Channel:    / theshackhome