Скачать или смотреть View Break in NX11

Use the View Break command to add multiple horizontal or vertical breaks to a drafting view. Two types of view breaks are available:

Regular, where two brake lines are added to the view and represent the conceptual gap on the drawing.

Single-sided, where only a single break line is added to the view. The second virtual break line is located past the corresponding end of the part and is not visible.

By default, NX sets the direction of the first break in a view to horizontal if the geometry in the view is wider than it is high. Otherwise, the break direction is set to vertical. You can also define the break direction by specifying a vector. However, when you add a new break to a view that already has a view break, the direction must be either parallel or perpendicular to the existing breaks.

You can add breaks to the following views:

Base views

Projected views

2D drawing views.

Section views created with simple or stepped section lines, and Break-out section views.