Crown Vic town car grand marquis hyper flash fix Led bulbs all around

I’ll be showing you on how to prevent the hyper flash after installing Led turn signals without using resistors and instead using an electronic Flasher

SAFETY FIRST Please use safety glasses
Not responsible for any damages caused to vehicle use video on your own risk

Tools needed
Safety Glasses
1/4 in ratchet
8mm socket
7mm socket
Wire cutters
Wire stripper
Electrical Tape
Cable Ties (Zip ties)

1. Disconnect the battery

2. Go under dash to Diagnostic Port and remove 2 7mm bolts

3 disconnect two small black plugs on Lighting Control Module(LCM)

4. Remove white pipe Christmas tree tie carefully

5. Remove 2 golden colored screws for LCM

6. Move LCM towards front of vehicle

7. Remove 12mm bolt holding on LCM BRACKET

8. remove the black connector right next to the gray connector

9. cut the two blue wires and connect them together

10 cut the two red/white wires diagonally from the blue wires previously mentioned

11. Connect the red/white wires together

12. Get flasher and connect the blue wire set into one terminal

13. Get the other set of conjoined red/white wires and connect to the other terminal of the flasher

14. Connect The black wire to a good body ground

15. Put LCM back with bracket

16. Tighten down LCM with golden screws

17. Put white Christmas tree tie back

18. Put the two 7mm bolts for diagnostic connector

Done

Make sure to use cable ties to make sure the flasher is secure and won’t fall when operating the vehicle