AR60 Weighted Brass Lockouts

STILL WORKING ON THE CHASSIS FILES!!
Thanks for the intrest but please be patient, I do this in my free time. Getting the instructions for the chassis files together takes I while, I hope you guys understand, thanks.

Just a quick one today, designed up some rear lockout for the AR60 axles that can accept 1/2in brass rods from some extra weight at the back for my 2.2 shafty.

Additional Hardware:

12 x M3 x 8mm Cap Head Screws

0-8x 1/2in x 18mm Brass/Metal rod

After the brass rod is cut to length it shoud just be a press fit into the printed part, the extra screws help keep the rods from sliding out.

I included 2 version, one for 0 degrees pinion angle and one at 45 degrees. the super steep one is only used for specify 2.2 shafty builds. Go for the 0 degrees one for anything else.

You may have to tweek expansion setting for the part to fit onto the axle properly.
Would recommend to print at 0.1 layer height for extra strength and at least 4 walls and 8 top and bottom.

I printed this out of Esun PLA Plus and it seems to hold up fine

you can use a Hack saw to cut up the brass

Thingiverse:
https://www.thingiverse.com/thing:584...