Honda Goldwing Front Wheel Bearing Replacement | Partzilla.com

Buy replacement front wheel bearings for a Honda Goldwing here: http://bit.ly/honda-goldwing-front-wh...

Pay attention to the parts: there are two DIFFERENT dust seals with different part numbers that you’ll need for this job, one for each side. You’ll also need two of the SAME radial ball bearings.

Learn how to replace the wheel bearings on a Honda Goldwing in this video from Partzilla.com. How do you know if your wheel bearings are worn? You may feel a little shimmy in the front end, or you might feel a clicking that radiates from the wheel through the handlebar.

Replacing the front wheel bearings on your Goldwing starts by removing the wheel. We’ll show you how to remove the fender and the brake calipers so that you can get that done. Then, we’ll remove the dust seals and use a bearing remover to get the bearings out. Then we’ll use a driver set to replace the wheel bearings on our Honda motorcycle, and then we’ll follow it up by replacing the dust seals on both sides.

Stay with us as we put everything back together again. John will show you a trick to keep both sides of the fork parallel, which is important to keep the motorcycle’s steering system from binding.

See a diagram of the front wheel on your Honda Goldwing here: https://www.partzilla.com/catalog/hon...

Need a bearing remover kit? Find one at Partzilla.com:
https://www.partzilla.com/product/suz...

How about a bearing driver kit? Find it here at Partzilla.com:
https://www.partzilla.com/product/aft...

You’re already working on the front end, let’s change the brake pads on your Honda Goldwing:
   • Goldwing Front Brake Pad Replacement ...  

Then you can change the rear brake pads on your Goldwing:
   • Honda Goldwing Rear Brake Pad Change ...  

Read how to do a Goldwing wheel bearing change step-by-step: https://www.partzilla.com/blog/honda/...

VIDEO HIGHLIGHTS:
Removing the fender - 2:35
Removing the calipers - 3:00
Removing the axle nut - 3:40
Removing the axle and wheel - 4:00
Removing wheel bearing seals - 4:20
Installing new bearings - 7:00
Installing the bearing dust seal - 8:00
Re-mounting the fender - 9:35
Re-mounting the front wheel - 10:50
Re-mounting the calipers - 13:30

Buy OEM Honda Goldwing GL1800 parts here:
https://www.partzilla.com/catalog/hon...

Talk to us:
Twitter:   / partzilla  
Facebook:   / partzilla  
Instagram:   / partzilla  

In the video we’re working with a 2007 Honda Goldwing GL1800, but you may have similar steps for your Honda motorcycle. If you’re not sure whether these steps apply to your motorcycle, leave a comment and we’ll get back to you.

RELATED CONTENT:

Honda Goldwing oil change:
   • Oil Change on a Honda Goldwing GL1800...  

Honda Goldwing air filter replacement:
   • Goldwing Air Filter Replacement | Par...